A 60 Anodic behavior of the NiO-Fe2O3-Cr2O3-Cu composite during the low-temperature electrolysis of aluminum / V. A. Kovrov, A. P. Khramov, Yu. P. Zaikov, V. M. Chumarev, E. N. Selivanov // Russian Journal of Non-Ferrous Metals. - 2014. - Vol. 55, № 1. - P8-14 Рубрики: ХИМИЧЕСКИЕ НАУКИ Кл.слова (ненормированные): ОКСИД ХРОМА -- АНОД -- ЭЛЕКТРОЛИЗ -- РАСТВОРЕНИЕ Аннотация: In order to fabricate oxide-metallic composites with the composition 25.3NiO-41.2Fe2O3-13.5Cr2O3-20.0Cu (wt %), the temperature and duration of sintering (1350°C, 30 min) that ensure the formation of the solid solution of chromium oxide in nickel ferrite have been determined. This material is tested as an anode for the electrolysis of the low-temperature solution with the composition 12.0NaF-36.8KF-51.2AlF3 (wt %), which was saturated with Al2O3 (t = 800°C). The amount of gaseous oxygen evolved on the anode was measured. It is shown that the main reaction on an anode at current density i = 0.015–1.0 A cm−2 is the oxidation of oxygen-containing anions from a melt with the formation of gaseous O2 and a substantial increase in the oxidation rate of the composite anode is observed at i > 1.0 A cm−2. The voltage across the electrolyzer (4.5 ± 0.5 V) and the anodic potential (2.43 ± 0.2 relative to the Al reference electrode) during a prolonged experiment (for 89 h, i = 0.4 A cm−2) indicate a stable and acceptable electrical conductivity of the material, while the dissolution rate, which was calculated by the weight loss (0.6 kg/yr) and volume loss (0.7 cm/yr), satisfy the requirements to inert anodes. |